How To Wire A 4 Gang Light Switch

Trends in lighting technology can make wiring a 4 gang light switch seem daunting if you’re not familiar with the process. But don’t worry: wiring a 4-gang light switch is one of the most straightforward do-it-yourself tasks, and requires just a few tools and supplies. This guide will walk you through the steps so you can get your light switch up and running in no time!

The first thing to know before starting any wiring project is safety first. Be sure to shut off all power to the circuit by switching the breaker off at the main breaker box. Test the circuit with a voltage tester to ensure that there is no power running through it. Then cover all outlets and switches with electrical tape until you are finished working on the circuit.

Now that you’re ready to start, you’ll need to remove the existing switch plate cover to expose the box. Unscrew the screws holding the plate to the wall, then pull the plate away. Next, use a screwdriver to unscrew the screws that hold the four wires in place. For each wire, you’ll attach it to the appropriate terminal on the 4-gang switch. Connect black wires to the common terminal and white wires to the neutral terminal. To complete the process, connect the ground wire to the ground terminal, if necessary. Finally, snugly secure the switch onto the wall and screw the switch plate back into place.

Keep in mind that the 4-gang switch should be installed in an area out of direct sunlight to reduce heat buildup. Also, never use wire nuts with more than two wires. Once you’ve completed all these steps, turn the power back on, erase the electrical tape, and test your switch to make sure it works correctly. Following these simple steps, you’ll master how to wire a 4 gang light switch in no time!

Trendi 4 Gang 2 Way 1x Intermediate Glossy 10 Amp Rocker Light Switch Gold